sysexits —
preferable exit codes for programs
According to style(9), it is not a good practice
to call exit(3) with arbitrary values to indicate a
failure condition when ending a program. Instead, the pre-defined exit codes
from sysexits should be used, so the caller of the
process can get a rough estimation about the failure class without looking
up the source code.
The successful exit is always indicated by a status of
0, or EX_OK. Error
numbers begin at
EX__BASE
to reduce the possibility of clashing with other exit statuses that random
programs may already return. The meaning of the codes is approximately as
follows:
- EX_USAGE
(64)
- The command was used incorrectly, e.g., with the wrong number of
arguments, a bad flag, a bad syntax in a parameter, or whatever.
- EX_DATAERR
(65)
- The input data was incorrect in some way. This should only be used for
user's data and not system files.
- EX_NOINPUT
(66)
- An input file (not a system file) did not exist or was not readable. This
could also include errors like “No message” to a mailer (if
it cared to catch it).
- EX_NOUSER
(67)
- The user specified did not exist. This might be used for mail addresses or
remote logins.
- EX_NOHOST
(68)
- The host specified did not exist. This is used in mail addresses or
network requests.
- EX_UNAVAILABLE
(69)
- A service is unavailable. This can occur if a support program or file does
not exist. This can also be used as a catchall message when something you
wanted to do doesn't work, but you don't know why.
- EX_SOFTWARE
(70)
- An internal software error has been detected. This should be limited to
non-operating system related errors as possible.
- EX_OSERR
(71)
- An operating system error has been detected. This is intended to be used
for such things as “cannot fork”, “cannot create
pipe”, or the like. It includes things like getuid returning a user
that does not exist in the passwd file.
- EX_OSFILE
(72)
- Some system file (e.g., /etc/passwd,
/var/run/utmp, etc.) does not exist, cannot be
opened, or has some sort of error (e.g., syntax error).
- EX_CANTCREAT
(73)
- A (user specified) output file cannot be created.
- EX_IOERR
(74)
- An error occurred while doing I/O on some file.
- EX_TEMPFAIL
(75)
- Temporary failure, indicating something that is not really an error. In
sendmail, this means that a mailer (e.g.) could not create a connection,
and the request should be reattempted later.
- EX_PROTOCOL
(76)
- The remote system returned something that was “not possible”
during a protocol exchange.
- EX_NOPERM
(77)
- You did not have sufficient permission to perform the operation. This is
not intended for file system problems, which should use
EX_NOINPUT or EX_CANTCREAT, but rather
for higher level permissions.
- EX_CONFIG
(78)
- Something was found in an unconfigured or misconfigured state.
The numerical values corresponding to the symbolical ones are
given in parenthesis for easy reference.
The sysexits file appeared somewhere after
4.3BSD.
This man page has been written by Jörg
Wunsch after the comments in
<sysexits.h>.
The choice of an appropriate exit value is often ambiguous.